TFS152.doc version 1.1 18.05.2000 vi telefilter filter specification tfs 152 page 1/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-52 / fax: (+49) 3328 4784-30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. measurement condition ambient temperature: 23 c input power level: 0 dbm terminating impedances: input: : 600 ? // -1 pf output : 600 ? // -1 pf characteristics remark: reference level for the relative attenuation a rel of the tfs 152 is the maximmum pass band attenuation, which is is defined as the insertion loss a e . the nominal frequency f n is fixed at 152,8 mhz without tolerance or limit. the values of relative attenuation a rel are guaranteed in the whole operating temperature range. the frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. d a t a typ. value tolerance / limit ______________________________________________________________________________________________________ insertion loss a e 2,8 max. 5 db (reference level) ______________________________________________________________________________________________________ nominal frequency f n 155,805 mhz 152,8 mhz ______________________________________________________________________________________________________ usable signal band width min. 10 khz ______________________________________________________________________________________________________ relative attenuation a rel f n + 910 khz 65 db min. 60 db ______________________________________________________________________________________________________ temperature coefficient of frequency tc f *) - 0,036 ppm/k2 - ______________________________________________________________________________________________________ frequency inversion temperature t o + 25 c - operating temperature range - 10 c ... + 50 c ______________________________________________________________________________________________________ *) ? f(hz) = tc f (ppm/k2) x ( ? t)2 x f to (mhz) generated: checked / approved:
TFS152.doc version 1.1 18.05.2000 vi telefilter filter specification tfs 152 page 2/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-52 / fax: (+49) 3328 4784-30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. construction, pin configuration and 50 ? ? ? ? matching network: (all dimensions in mm) s 152 m20 3 , 0 0 , 3 datecode 1 ? input 2 ? ground 3 ? ground 4 ? output datecode: year+week k 1998 l 1999 m 2000 ...
TFS152.doc version 1.1 18.05.2000 vi telefilter filter specification tfs 152 page 3/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-52 / fax: (+49) 3328 4784-30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. stability characteristics after the following tests the filter shall meet the whole specification: 1. shock: 500g, 18 ms, half sine wave, 3 sho cks each pl ane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans; din iec 68 t2 - 6 3. damp heat: 25 c to 55c / 95% r.h. / 10 cycles (cycle) din iec 68 - 2 ? 30 db 4. resistance to solder heat (reflow): max. 2 times reflow process; for temperature conditions refer to the attached "air reflow temperature conditions" on page 4;
TFS152.doc version 1.1 18.05.2000 vi telefilter filter specification tfs 152 page 4/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-52 / fax: (+49) 3328 4784-30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. air reflow temperature conditions 1st and 2nd air reflow profile name: pre-heating periods main-heating periods peak temperature temperature: 150 c - 170 c over 200 c 255 c 5 c time: 60 sec. - 90 sec. 20 sec. - 25 sec. air reflow temperature profile 0 20 40 60 80 100 120 140 160 180 200 220 240 260 0 20 40 60 80 100 120 140 160 180 200 220 240 time / sec. temperature / c table for temperature vs. time during the air reflow process tolerance of temperatures: 5 c time / sec. temperature / c time / sec. temperature / c 0 23 140 160 10 34 150 161 20 46 160 164 30 60 170 170 40 80 180 180 50 103 190 205 60 121 195 230 70 134 200 255 80 143 205 230 90 150 210 205 100 154 215 180 110 156 220 165 120 158 230 140 130 159 240 120
TFS152.doc version 1.1 18.05.2000 vi telefilter filter specification tfs 152 page 5/5 vi telefilter vectron international, inc. potsdamer stra?e 18 267 lowell road d 14 513 teltow / germany hudson, nh 03051 / usa tel: (+49) 3328 4784-52 / fax: (+49) 3328 4784-30 tel: (603) 598-0070 fax: (603) 598-0075 e-mail: tft@telefilter.com e-mail: vti@vtinh.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. history version reason of changes name date 1.1 generation of complete specification dr. wall 18.05.2000
|
